P207C — Intake manifold tuning valve position sensor signal low, bank 2
| Meaning | The control unit sees too low a voltage from the intake manifold tuning valve's position sensor or switch on bank 2, the side of the engine opposite cylinder 1. This usually indicates an open circuit or a short to ground. That valve isn't managed reliably. |
| Family | Powertrain (P) |
Typical symptoms
Reduced torque or power at certain revs
Rough idle
Less lively acceleration
No obvious symptoms in some cases
Common causes
Corroded or disconnected connector
Faulty position sensor
Missing sensor supply voltage
Control unit problem (rare)
What to do
How to read code P207C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P207C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (7C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P207C mean?
Intake manifold tuning valve position sensor signal low, bank 2. The control unit sees too low a voltage from the intake manifold tuning valve's position sensor or switch on bank 2, the side of the engine opposite cylinder 1. This usually indicates an open circuit or a short to ground. That valve isn't managed reliably.
Can I keep driving with code P207C active?
With caution: limp mode possible, have it checked soon
Common causes — P207C
Bank 2 sensor wiring shorted to ground or broken Corroded or disconnected connector Faulty position sensor Missing sensor supply voltage Control unit problem (rare)
How do you fix code P207C?
First check the connector and wiring of the bank 2 sensor, looking for pinched wires or corrosion. It isn't urgent for safety, but have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P207B — Read the transmission fault memory and rectify the...
- Next code: P207D — Missing or incorrect CAN message from the ignition...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying