P20BC — Cylinder 10 fuel injector Y62y10: circuit fault
| Meaning | The control unit detected a problem in the electrical circuit of the cylinder 10 injector, labelled Y62y10. It may be an open circuit, a short or an abnormal resistance. The code is manufacturer-defined and the label suggests a 12-cylinder Mercedes-Benz, to be confirmed. |
| Family | Powertrain (P) |
Typical symptoms
Engine running unevenly
Loss of power
Uneven idle
Smell of unburnt fuel from the exhaust
Common causes
Damaged wiring or connector
Corroded contacts
Fault in the injector driver in the control unit
Rarely, the engine control unit
What to do
How to read code P20BC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P20BC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (BC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P20BC mean?
Cylinder 10 fuel injector Y62y10: circuit fault. The control unit detected a problem in the electrical circuit of the cylinder 10 injector, labelled Y62y10. It may be an open circuit, a short or an abnormal resistance. The code is manufacturer-defined and the label suggests a 12-cylinder Mercedes-Benz, to be confirmed.
Can I keep driving with code P20BC active?
With caution: limp mode possible, have it checked soon
Common causes — P20BC
Electrically failed injector Damaged wiring or connector Corroded contacts Fault in the injector driver in the control unit Rarely, the engine control unit
How do you fix code P20BC?
Check the connector and wiring of the cylinder 10 injector and have the circuit measured. If the engine runs unevenly avoid heavy loads and have it checked soon: unburnt fuel damages the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P20BB — Cylinder 8 fuel injector Y62y8: circuit fault
- Next code: P20BD — Left camshaft to crankshaft timing correlation err...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying