P20DC — Accelerator pedal sensor: channel 1 open circuit
| Meaning | The control unit found the signal of channel 1 of the accelerator pedal position sensor open, as if the wire were disconnected. The pedal has two channels for safety: if one is missing, the control unit may limit power. The code is manufacturer-defined and the reference is Mercedes-Benz style. |
| Family | Powertrain (P) |
Typical symptoms
Limited power or limp-home mode
Slow or no throttle response
Irregular idle
Cruise control unusable
Common causes
Broken or damaged wire in the harness
Faulty pedal sensor
Ground or supply problem at the sensor
Engine control unit, rarely
What to do
How to read code P20DC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P20DC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (DC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P20DC mean?
Accelerator pedal sensor: channel 1 open circuit. The control unit found the signal of channel 1 of the accelerator pedal position sensor open, as if the wire were disconnected. The pedal has two channels for safety: if one is missing, the control unit may limit power. The code is manufacturer-defined and the reference is Mercedes-Benz style.
Can I keep driving with code P20DC active?
With caution: limp mode possible, have it checked soon
Common causes — P20DC
Corroded or poorly seated pedal connector Broken or damaged wire in the harness Faulty pedal sensor Ground or supply problem at the sensor Engine control unit, rarely
How do you fix code P20DC?
First check the pedal connector and the condition of the wiring. With limited power the car can be unsafe when overtaking or at junctions: have it checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P20DB — CAN error on the torque request from the ESP contr...
- Next code: P20DD — Accelerator pedal sensor: channel 1 short circuit
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying