P20DB — CAN error on the torque request from the ESP control unit (variant)
| Meaning | A second code with the same title as the previous one: the ESP control unit CAN torque request message is not arriving correctly. The reference indicates Mercedes-Benz, but I cannot say for certain what separates the two variants. |
| Family | Powertrain (P) |
Typical symptoms
Engine warning light on
Traction control out of service
Other warning lights on at the same time
Reduced power at times
Common causes
Damaged wiring or connectors
Unstable power supply
ESP control unit failure
Software problem between control units
What to do
How to read code P20DB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P20DB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (DB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P20DB mean?
CAN error on the torque request from the ESP control unit (variant). A second code with the same title as the previous one: the ESP control unit CAN torque request message is not arriving correctly. The reference indicates Mercedes-Benz, but I cannot say for certain what separates the two variants.
Can I keep driving with code P20DB active?
With caution: limp mode possible, have it checked soon
Common causes — P20DB
Disturbance on the CAN network Damaged wiring or connectors Unstable power supply ESP control unit failure Software problem between control units
How do you fix code P20DB?
Same checks as the neighbouring code: battery, grounds, connectors and a full module scan. Drive carefully until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P20DA — CAN error on the torque request from the ESP contr...
- Next code: P20DC — Accelerator pedal sensor: channel 1 open circuit
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying