P2119 — Throttle body: range or performance fault
| Meaning | The engine computer found that the electronic throttle does not move or position itself as commanded, within the allowed tolerances. It may be dirty, worn or not properly calibrated. The engine may run poorly or in a reduced mode. |
| Family | Powertrain (P) |
Typical symptoms
Rough or too-high idle
Delayed or jerky pedal response
Reduced power or limp mode
Stalling at low rpm
Common causes
Wear of the motor or internal gears
Throttle relearn not done after cleaning or replacement
Vacuum leaks upsetting engine load readings
Connector or wiring with poor contact
Position sensors with inconsistent signals
What to do
How to read code P2119
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P2119 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (19) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2119 mean?
Throttle body: range or performance fault. The engine computer found that the electronic throttle does not move or position itself as commanded, within the allowed tolerances. It may be dirty, worn or not properly calibrated. The engine may run poorly or in a reduced mode.
Can I keep driving with code P2119 active?
With caution: limp mode possible, have it checked soon
Common causes — P2119
Dirt deposits in the throttle body Wear of the motor or internal gears Throttle relearn not done after cleaning or replacement Vacuum leaks upsetting engine load readings Connector or wiring with poor contact Position sensors with inconsistent signals
How do you fix code P2119?
First check throttle cleanliness and have the relearn procedure done with the diagnostic tool. Also check for vacuum leaks. If power is reduced, drive carefully.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2118 — Throttle motor: current out of range or poor perfo...
- Next code: P211A — Throttle actuator B: stuck in the open position
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance