P213A — EGR throttle control circuit B: open circuit
| Meaning | The control unit has detected that the electrical circuit controlling the EGR throttle valve (circuit "B") is open, meaning there is no continuity. It therefore cannot command the valve as intended. The exact meaning of "B" can differ from one manufacturer to another. |
| Family | Powertrain (P) |
Typical symptoms
Rough or unstable idle
Loss of power or sluggish throttle response
Black smoke or a stronger exhaust smell than usual
Engine may enter limp mode
Common causes
Broken wire or intermittent contact in the circuit
Internal failure of the EGR throttle actuator
Power supply or ground problem on the circuit
Faulty engine control unit (rare)
What to do
How to read code P213A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P213A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (3A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P213A mean?
EGR throttle control circuit B: open circuit. The control unit has detected that the electrical circuit controlling the EGR throttle valve (circuit "B") is open, meaning there is no continuity. It therefore cannot command the valve as intended. The exact meaning of "B" can differ from one manufacturer to another.
Can I keep driving with code P213A active?
With caution: limp mode possible, have it checked soon
Common causes — P213A
Loose, corroded or damaged connector at the EGR valve or EGR throttle Broken wire or intermittent contact in the circuit Internal failure of the EGR throttle actuator Power supply or ground problem on the circuit Faulty engine control unit (rare)
How do you fix code P213A?
First check the connector and wiring going to the EGR valve, looking for moisture, corrosion, pulled or burnt wires. You can drive short distances, but don't put it off for long: a valve that doesn't respond can worsen drivability and foul the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2139 — Pedal/throttle sensors D and F: readings do not ag...
- Next code: P213B — EGR throttle control B: range/performance problem
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance