P218F — Reductant no flow detected (AdBlue)
| Meaning | The control unit has detected that the reductant fluid (such as AdBlue), used in the system that cleans nitrogen oxides from diesel exhaust, is not flowing when it should. If the fluid doesn't reach the exhaust, the system can't cut emissions. On some vehicles the control unit may restrict restarting after a while. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system fault message on the dash
Warning of a possible restart restriction (on some models)
Reduced power in some cases
Fluid level showing low even after topping up
Common causes
Clogged fluid filter or line
Dosing injector or nozzle blocked by crystals
Failed fluid pump
Leak or kinked hose in the circuit
Faulty tank sensor or heater
What to do
How to read code P218F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P218F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (8F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P218F mean?
Reductant no flow detected (AdBlue). The control unit has detected that the reductant fluid (such as AdBlue), used in the system that cleans nitrogen oxides from diesel exhaust, is not flowing when it should. If the fluid doesn't reach the exhaust, the system can't cut emissions. On some vehicles the control unit may restrict restarting after a while.
Can I keep driving with code P218F active?
With caution: limp mode possible, have it checked soon
Common causes — P218F
Empty fluid tank or frozen fluid Clogged fluid filter or line Dosing injector or nozzle blocked by crystals Failed fluid pump Leak or kinked hose in the circuit Faulty tank sensor or heater
How do you fix code P218F?
Check the fluid level right away and make sure the tank isn't frozen. If the level is fine, have the lines, filter and dosing injector inspected. Don't wait too long, as some cars limit restarting if the fault persists.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P218E — Throttle/fuel inhibit circuit B signal high
- Next code: P2190 — System too rich at idle, bank 2
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance