P2191 — System too lean at higher load, bank 1
| Meaning | The control unit has found that the mixture on bank 1, the side that includes cylinder 1, is too lean when the engine is under load: there is too little fuel for the amount of air. An engine working hard in this state can struggle and run hotter. |
| Family | Powertrain (P) |
Typical symptoms
Lack of power when accelerating or climbing
Jerks or flat spots under load
Rough idle
Possible popping or hesitation
Harder starting
Common causes
Low fuel pressure (weak pump or clogged filter)
Dirty or partly blocked injectors
Dirty air flow meter reading more air than real
Exhaust leak ahead of the oxygen sensor
Faulty bank 1 oxygen sensor
What to do
How to read code P2191
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2191 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (91) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2191 mean?
System too lean at higher load, bank 1. The control unit has found that the mixture on bank 1, the side that includes cylinder 1, is too lean when the engine is under load: there is too little fuel for the amount of air. An engine working hard in this state can struggle and run hotter.
Can I keep driving with code P2191 active?
With caution: limp mode possible, have it checked soon
Common causes — P2191
Air leak after the air flow meter (hoses, gaskets, manifold) Low fuel pressure (weak pump or clogged filter) Dirty or partly blocked injectors Dirty air flow meter reading more air than real Exhaust leak ahead of the oxygen sensor Faulty bank 1 oxygen sensor
How do you fix code P2191?
Check first for air leaks and the condition of the intake hoses, then the fuel pressure. A lean mixture under load can overheat the engine, so avoid demanding trips until it's sorted.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2190 — System too rich at idle, bank 2
- Next code: P2192 — System too rich at higher load, bank 1
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance