P227C — Barometric pressure sensor C circuit low
| Meaning | The electrical signal from barometric pressure sensor 'C' is lower than the control unit expects. It usually points to a wire shorted to ground, a missing supply or a faulty sensor. Which sensor is 'C' depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Possible reduced-power mode
Smoke from the exhaust on diesels
Irregular idle or revs in some cases
Common causes
Corroded connector or damaged pin
Faulty sensor
Missing or low sensor supply voltage
Internal fault in the control unit, rare
What to do
How to read code P227C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P227C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (7C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P227C mean?
Barometric pressure sensor C circuit low. The electrical signal from barometric pressure sensor 'C' is lower than the control unit expects. It usually points to a wire shorted to ground, a missing supply or a faulty sensor. Which sensor is 'C' depends on the manufacturer.
Can I keep driving with code P227C active?
With caution: limp mode possible, have it checked soon
Common causes — P227C
Wiring shorted to ground Corroded connector or damaged pin Faulty sensor Missing or low sensor supply voltage Internal fault in the control unit, rare
How do you fix code P227C?
First check the connector and wiring, looking for chafing or moisture. Then the sensor's supply has to be tested. You can usually drive carefully, but engine output may be reduced.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P227B — Barometric pressure sensor C range/performance
- Next code: P227D — Barometric pressure sensor C: signal too high
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3