P22C1 — Bank 2 Sensor 2 O2 sensor negative current circuit high
| Meaning | The engine computer sees too high a voltage on the negative control current circuit of the downstream wide-band oxygen sensor on bank 2. It may come from a wire touching a power supply or from a failed sensor. The sensor does not give a reliable reading. |
| Family | Powertrain (P) |
Typical symptoms
Usually normal driving
Other codes for the downstream sensor
Possible failure at an emissions inspection
Common causes
Corroded or damaged connector
Failed sensor
Wiring damaged by heat
Faulty engine computer, uncommon
What to do
How to read code P22C1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22C1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (C1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22C1 mean?
Bank 2 Sensor 2 O2 sensor negative current circuit high. The engine computer sees too high a voltage on the negative control current circuit of the downstream wide-band oxygen sensor on bank 2. It may come from a wire touching a power supply or from a failed sensor. The sensor does not give a reliable reading.
Can I keep driving with code P22C1 active?
With caution: limp mode possible, have it checked soon
Common causes — P22C1
Wire touching a power supply Corroded or damaged connector Failed sensor Wiring damaged by heat Faulty engine computer, uncommon
How do you fix code P22C1?
Check the connector and wires of the bank 2 sensor behind the catalytic converter for burn marks or wires in contact. It is not an emergency, but don't ignore it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22C0 — Bank 2 Sensor 2 O2 sensor negative current circuit...
- Next code: P22C2 — Bank 2 Sensor 2 O2 sensor pumping current trim cir...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3