P22C3 — Bank 2 Sensor 2 O2 sensor pumping current trim circuit low
| Meaning | The engine computer sees too low a voltage on the pumping current trim circuit of the downstream wide-band oxygen sensor on bank 2. It may indicate a grounded wire or a faulty sensor. The sensor's calibration is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Usually no difference in driving
Possible other codes for the downstream sensor
Possible failure at an emissions inspection
Common causes
Wet or corroded connector
Failed sensor
Crushed or burnt wiring
Faulty engine computer, uncommon
What to do
How to read code P22C3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22C3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (C3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22C3 mean?
Bank 2 Sensor 2 O2 sensor pumping current trim circuit low. The engine computer sees too low a voltage on the pumping current trim circuit of the downstream wide-band oxygen sensor on bank 2. It may indicate a grounded wire or a faulty sensor. The sensor's calibration is not reliable.
Can I keep driving with code P22C3 active?
With caution: limp mode possible, have it checked soon
Common causes — P22C3
Wire grounded through damaged insulation Wet or corroded connector Failed sensor Crushed or burnt wiring Faulty engine computer, uncommon
How do you fix code P22C3?
Inspect the wiring and connector of the bank 2 sensor behind the catalytic converter, especially near hot parts or the body. It is not urgent, but get it checked within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22C2 — Bank 2 Sensor 2 O2 sensor pumping current trim cir...
- Next code: P22C4 — Bank 2 Sensor 2 O2 sensor pumping current trim cir...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3