Skip to content
Fault code dictionary (DTC)

P22C4 — Bank 2 Sensor 2 O2 sensor pumping current trim circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer sees too high a voltage on the pumping current trim circuit of the downstream wide-band oxygen sensor on bank 2. It may be caused by a wire touching a power supply or a failed sensor. The sensor reading is not reliable.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Usually normal driving
Other codes for the downstream sensor
Possible failure at an emissions inspection

Common causes

Wire touching a power supply
Corroded connector or bent terminals
Failed sensor
Wiring damaged by heat
Faulty engine computer, uncommon

What to do

Check the connector and wires of the bank 2 sensor behind the catalytic converter for burn marks or abnormal contacts. It is not an emergency, but don't put it off for long.

How to read code P22C4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P22C4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (C4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P22C4 mean?

Bank 2 Sensor 2 O2 sensor pumping current trim circuit high. The engine computer sees too high a voltage on the pumping current trim circuit of the downstream wide-band oxygen sensor on bank 2. It may be caused by a wire touching a power supply or a failed sensor. The sensor reading is not reliable.

Can I keep driving with code P22C4 active?

With caution: limp mode possible, have it checked soon

Common causes — P22C4

Wire touching a power supply Corroded connector or bent terminals Failed sensor Wiring damaged by heat Faulty engine computer, uncommon

How do you fix code P22C4?

Check the connector and wires of the bank 2 sensor behind the catalytic converter for burn marks or abnormal contacts. It is not an emergency, but don't put it off for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes