Skip to content
Fault code dictionary (DTC)

P22C6 — Turbo compressor outlet valve control circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer sees too low a voltage in the control circuit of the valve at the turbocharger compressor outlet. This often means a grounded wire or a shorted solenoid. The valve may not respond as intended.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Possible loss of power
Irregular turbo response
Reduced-power mode in some cases

Common causes

Wire grounded through damaged insulation
Shorted solenoid valve
Wet or corroded connector
Crushed or burnt wiring
Faulty engine computer, uncommon

What to do

Inspect the wiring and connector of the valve on the turbo for worn or burnt wires. If you notice a loss of power, avoid heavy loads and have it checked soon.

How to read code P22C6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P22C6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (C6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P22C6 mean?

Turbo compressor outlet valve control circuit low. The engine computer sees too low a voltage in the control circuit of the valve at the turbocharger compressor outlet. This often means a grounded wire or a shorted solenoid. The valve may not respond as intended.

Can I keep driving with code P22C6 active?

With caution: limp mode possible, have it checked soon

Common causes — P22C6

Wire grounded through damaged insulation Shorted solenoid valve Wet or corroded connector Crushed or burnt wiring Faulty engine computer, uncommon

How do you fix code P22C6?

Inspect the wiring and connector of the valve on the turbo for worn or burnt wires. If you notice a loss of power, avoid heavy loads and have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes