P235A — Cylinder 10: combustion pressure variation too high
| Meaning | The control unit detected that the pressure in cylinder 10 varies from one cycle to the next more than expected. This is a standard code and points to uneven combustion in that cylinder. This check only exists on engines fitted with in-cylinder pressure sensors, so it is rare and tied to specific engine versions. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power when accelerating
Check engine light on
Unusual noise or knocking from the engine
Irregular fuel consumption
Hard starting in some cases
Common causes
Worn or faulty spark plug or ignition coil on cylinder 10
Carbon buildup or a sealing problem in the combustion chamber
Cylinder pressure sensor giving an unstable signal
Mechanical problem, such as a valve or piston rings
Outdated control unit software
What to do
How to read code P235A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P235A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (5A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P235A mean?
Cylinder 10: combustion pressure variation too high. The control unit detected that the pressure in cylinder 10 varies from one cycle to the next more than expected. This is a standard code and points to uneven combustion in that cylinder. This check only exists on engines fitted with in-cylinder pressure sensors, so it is rare and tied to specific engine versions.
Can I keep driving with code P235A active?
With caution: limp mode possible, have it checked soon
Common causes — P235A
Cylinder 10 injector delivering fuel unevenly Worn or faulty spark plug or ignition coil on cylinder 10 Carbon buildup or a sealing problem in the combustion chamber Cylinder pressure sensor giving an unstable signal Mechanical problem, such as a valve or piston rings Outdated control unit software
How do you fix code P235A?
Have the live data read to see whether the problem affects only cylinder 10. Check that cylinder's spark plug, coil and injector first. Do not keep driving for long in this condition: uneven combustion can damage the catalytic converter and the engine.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2359 — Cylinder 10 pressure variation too low
- Next code: P235B — Cylinder 10: poor combustion performance
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit