P235B — Cylinder 10: poor combustion performance
| Meaning | The control unit judged that combustion in cylinder 10 is not performing as it should. The code is standard, but it only describes the symptom: the cause can be in the ignition, the fuel supply or the mechanical side of that cylinder. A proper diagnosis is needed to tell them apart. |
| Family | Powertrain (P) |
Typical symptoms
Lack of power
Check engine light on or flashing
Smell of unburnt fuel from the exhaust
Higher fuel consumption
Jerking when accelerating
Common causes
Dirty or leaking injector on cylinder 10
Low compression from worn valves, rings or gasket
Faulty cylinder pressure sensor or its wiring
Air leak or intake problem on that cylinder
Timing problem or control unit software issue
What to do
How to read code P235B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P235B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (5B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P235B mean?
Cylinder 10: poor combustion performance. The control unit judged that combustion in cylinder 10 is not performing as it should. The code is standard, but it only describes the symptom: the cause can be in the ignition, the fuel supply or the mechanical side of that cylinder. A proper diagnosis is needed to tell them apart.
Can I keep driving with code P235B active?
With caution: limp mode possible, have it checked soon
Common causes — P235B
Faulty spark plug or coil on cylinder 10 Dirty or leaking injector on cylinder 10 Low compression from worn valves, rings or gasket Faulty cylinder pressure sensor or its wiring Air leak or intake problem on that cylinder Timing problem or control unit software issue
How do you fix code P235B?
Have the ignition and injector of cylinder 10 checked first, then compression if needed. If the light is flashing, stop driving: unburnt fuel can ruin the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P235A — Cylinder 10: combustion pressure variation too hig...
- Next code: P235C — Cylinder 11: pressure sensor circuit fault
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit