P235C — Cylinder 11: pressure sensor circuit fault
| Meaning | The control unit detected a general fault in the circuit of the sensor that measures pressure in cylinder 11. The code does not say whether the problem is electrical or in the sensor itself. Engines with 11 or more cylinders are very rare, so the code is defined by the standard but seldom seen. |
| Family | Powertrain (P) |
Typical symptoms
Uneven engine running
Slight loss of power
Less precise combustion control
Slightly abnormal fuel consumption
Sometimes no obvious symptoms
Common causes
Faulty cylinder pressure sensor
Faulty sensor ground or supply
Moisture or contamination in the connector
Internal control unit fault, which is rare
What to do
How to read code P235C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P235C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (5C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P235C mean?
Cylinder 11: pressure sensor circuit fault. The control unit detected a general fault in the circuit of the sensor that measures pressure in cylinder 11. The code does not say whether the problem is electrical or in the sensor itself. Engines with 11 or more cylinders are very rare, so the code is defined by the standard but seldom seen.
Can I keep driving with code P235C active?
With caution: limp mode possible, have it checked soon
Common causes — P235C
Damaged or corroded sensor wiring or connector Faulty cylinder pressure sensor Faulty sensor ground or supply Moisture or contamination in the connector Internal control unit fault, which is rare
How do you fix code P235C?
First check the sensor connector and wiring for broken wires, corrosion or moisture. You can drive carefully for a short time, but have it checked soon because the control unit may manage that cylinder poorly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P235B — Cylinder 10: poor combustion performance
- Next code: P235D — Cylinder 11: pressure sensor signal out of range
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit