P235D — Cylinder 11: pressure sensor signal out of range
| Meaning | The control unit is receiving a signal from the cylinder 11 pressure sensor that does not match what it expects, without being a clear electrical fault. It can mean an aged or dirty sensor, or a genuinely abnormal reading in the cylinder. The code is standard and applies to very rare engines with 11 or more cylinders. |
| Family | Powertrain (P) |
Typical symptoms
Occasionally uneven running
Slight drop in performance
Combustion managed less accurately
Fuel consumption a little off
Often no obvious symptoms
Common causes
Connector or wiring with abnormal resistance
Carbon deposits affecting the sensor
A real combustion problem in cylinder 11
Software or control unit fault, which is rare
What to do
How to read code P235D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P235D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (5D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P235D mean?
Cylinder 11: pressure sensor signal out of range. The control unit is receiving a signal from the cylinder 11 pressure sensor that does not match what it expects, without being a clear electrical fault. It can mean an aged or dirty sensor, or a genuinely abnormal reading in the cylinder. The code is standard and applies to very rare engines with 11 or more cylinders.
Can I keep driving with code P235D active?
With caution: limp mode possible, have it checked soon
Common causes — P235D
Dirty, worn or drifting cylinder pressure sensor Connector or wiring with abnormal resistance Carbon deposits affecting the sensor A real combustion problem in cylinder 11 Software or control unit fault, which is rare
How do you fix code P235D?
Have the wiring and connector checked, then compare the signal with the other cylinders to see whether the sensor or the cylinder is out of norm. It is not an immediate emergency, but do not put it off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P235C — Cylinder 11: pressure sensor circuit fault
- Next code: P235E — Cylinder 11: pressure sensor signal too low
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit