P235E — Cylinder 11: pressure sensor signal too low
| Meaning | The control unit reads a voltage on the cylinder 11 pressure sensor circuit that is lower than the expected minimum. It usually points to a wire shorted to ground, a break, or a faulty sensor. The code is standard but applies to engines with 11 or more cylinders, which are very rare. |
| Family | Powertrain (P) |
Typical symptoms
Occasionally uneven running
Slight loss of power
Combustion managed without reliable data from that cylinder
Variable fuel consumption
Often no obvious symptoms
Common causes
Corroded connector or broken contact
Faulty cylinder pressure sensor
Missing or low sensor supply
Damaged control unit input, which is rare
What to do
How to read code P235E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P235E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (5E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P235E mean?
Cylinder 11: pressure sensor signal too low. The control unit reads a voltage on the cylinder 11 pressure sensor circuit that is lower than the expected minimum. It usually points to a wire shorted to ground, a break, or a faulty sensor. The code is standard but applies to engines with 11 or more cylinders, which are very rare.
Can I keep driving with code P235E active?
With caution: limp mode possible, have it checked soon
Common causes — P235E
Sensor wire shorted to ground Corroded connector or broken contact Faulty cylinder pressure sensor Missing or low sensor supply Damaged control unit input, which is rare
How do you fix code P235E?
First check the condition of the sensor wiring and connector, especially where wires rub or get hot. Have it checked soon, but this is not a fault that forces you to stop immediately.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P235D — Cylinder 11: pressure sensor signal out of range
- Next code: P235F — Cylinder 11: pressure sensor signal too high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit