P236F — Cylinder 12 combustion performance problem
| Meaning | The control unit judged that combustion in cylinder 12 is not reaching the expected values. This does not necessarily mean a mechanical failure: ignition, fuel supply or compression could be the cause. Thresholds and checks vary by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Engine shaking or jerking
Loss of power
Higher fuel use than normal
Smell of unburned fuel from the exhaust
Common causes
Dirty or faulty cylinder 12 injector
Low compression from valves or piston rings
Air leak near cylinder 12
Damaged wiring or connector on the injector or coil
What to do
How to read code P236F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P236F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (6F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P236F mean?
Cylinder 12 combustion performance problem. The control unit judged that combustion in cylinder 12 is not reaching the expected values. This does not necessarily mean a mechanical failure: ignition, fuel supply or compression could be the cause. Thresholds and checks vary by manufacturer.
Can I keep driving with code P236F active?
With caution: limp mode possible, have it checked soon
Common causes — P236F
Worn spark plug or coil on cylinder 12 Dirty or faulty cylinder 12 injector Low compression from valves or piston rings Air leak near cylinder 12 Damaged wiring or connector on the injector or coil
How do you fix code P236F?
First check the spark plug, coil and injector of cylinder 12, swapping them with another cylinder to see whether the problem follows. If the engine jerks, avoid heavy loads: unburned fuel damages the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P236E — Cylinder 12 pressure variation too high
- Next code: P2370 — Fuel volume regulator B: open control circuit
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit