P2370 — Fuel volume regulator B: open control circuit
| Meaning | The control unit finds no continuity in the control circuit of fuel volume regulator B. This part meters how much fuel goes to the high-pressure pump, typical of direct-injection and diesel engines. The circuit appears to be broken. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting or no start
Loss of power
Engine stalling or limp mode
Uneven running
Common causes
Broken wire in the harness
Faulty fuel volume regulator
Poor contact at the control unit
Wiring damaged by heat or rubbing
What to do
How to read code P2370
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2370 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (70) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2370 mean?
Fuel volume regulator B: open control circuit. The control unit finds no continuity in the control circuit of fuel volume regulator B. This part meters how much fuel goes to the high-pressure pump, typical of direct-injection and diesel engines. The circuit appears to be broken.
Can I keep driving with code P2370 active?
With caution: limp mode possible, have it checked soon
Common causes — P2370
Regulator connector unplugged or corroded Broken wire in the harness Faulty fuel volume regulator Poor contact at the control unit Wiring damaged by heat or rubbing
How do you fix code P2370?
Check the regulator connector and wiring, then test the circuit for continuity. With power loss or stalling, act soon, as it can become a safety issue on the road.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P236F — Cylinder 12 combustion performance problem
- Next code: P2371 — Fuel volume regulator B: control performance
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit