P2372 — Fuel volume regulator B: control circuit low
| Meaning | The control unit reads a lower voltage than expected on the control circuit of regulator B. It usually points to a short to ground or an internal regulator fault. The regulator meters fuel going to the high-pressure pump. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting
Loss of power
Limp mode
Sudden stalling
Common causes
Internal winding fault in the regulator
Wet or corroded connector
Pinched or chafed wiring
Driver fault inside the control unit
What to do
How to read code P2372
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2372 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (72) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2372 mean?
Fuel volume regulator B: control circuit low. The control unit reads a lower voltage than expected on the control circuit of regulator B. It usually points to a short to ground or an internal regulator fault. The regulator meters fuel going to the high-pressure pump.
Can I keep driving with code P2372 active?
With caution: limp mode possible, have it checked soon
Common causes — P2372
Wire shorted to ground Internal winding fault in the regulator Wet or corroded connector Pinched or chafed wiring Driver fault inside the control unit
How do you fix code P2372?
Inspect the wiring and connector for chafing or moisture, then test the regulator with a meter. Don't delay if the car is losing power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2371 — Fuel volume regulator B: control performance
- Next code: P2373 — Fuel volume regulator B: control circuit high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit