Skip to content
Fault code dictionary (DTC)

P2382 — EGR sensor D circuit: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a lower-than-normal voltage on the circuit of one of the EGR system sensors (the one labelled "D"). Which exact sensor D refers to is up to the manufacturer (for example valve position, pressure or exhaust gas temperature), and for some brands I have no reliable information, so your car's service manual is needed. In practice the sensor signal is weak or missing.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough or unstable idle
Loss of power or sluggish throttle response
Black or heavier exhaust smoke on diesels
On some cars the engine goes into limp mode

Common causes

Sensor wire shorted to ground or with damaged insulation
Corroded connector or loose terminals
Faulty EGR sensor
Dirty or stuck EGR valve, if the sensor is built into it
Sensor power supply interrupted or faulty
Faulty control unit (rare)

What to do

Have a scan tool show which sensor letter D refers to on your car, and visually check the wiring and connector. You can drive short distances, but don't put it off for long: a faulty EGR raises emissions and over time can foul and damage other components.

How to read code P2382

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2382 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (82) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2382 mean?

EGR sensor D circuit: signal too low. The control unit measured a lower-than-normal voltage on the circuit of one of the EGR system sensors (the one labelled "D"). Which exact sensor D refers to is up to the manufacturer (for example valve position, pressure or exhaust gas temperature), and for some brands I have no reliable information, so your car's service manual is needed. In practice the sensor signal is weak or missing.

Can I keep driving with code P2382 active?

With caution: limp mode possible, have it checked soon

Common causes — P2382

Sensor wire shorted to ground or with damaged insulation Corroded connector or loose terminals Faulty EGR sensor Dirty or stuck EGR valve, if the sensor is built into it Sensor power supply interrupted or faulty Faulty control unit (rare)

How do you fix code P2382?

Have a scan tool show which sensor letter D refers to on your car, and visually check the wiring and connector. You can drive short distances, but don't put it off for long: a faulty EGR raises emissions and over time can foul and damage other components.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes