P2384 — EGR sensor D circuit: intermittent signal
| Meaning | The control unit sees the signal from EGR sensor "D" appearing and disappearing, or jumping around in an unrealistic way. Which sensor "D" is depends on the manufacturer, and for some brands I have no reliable information. Usually the problem is a contact that drops out now and then, for example with vibration or heat. |
| Family | Powertrain (P) |
Typical symptoms
Idle that hunts for no reason
Occasional small jerks or power dips
Problem that only appears when hot or on rough roads
Intermittent exhaust smoke on diesels
Common causes
Wire with a partly broken or chafed internal strand
Sensor with an internal fault that shows up intermittently
Sensor ground or supply with an unstable contact
Moisture in the connector
Control unit input circuit problem (rare)
What to do
How to read code P2384
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2384 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (84) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2384 mean?
EGR sensor D circuit: intermittent signal. The control unit sees the signal from EGR sensor "D" appearing and disappearing, or jumping around in an unrealistic way. Which sensor "D" is depends on the manufacturer, and for some brands I have no reliable information. Usually the problem is a contact that drops out now and then, for example with vibration or heat.
Can I keep driving with code P2384 active?
With caution: limp mode possible, have it checked soon
Common causes — P2384
Sensor connector with corroded or loose contacts Wire with a partly broken or chafed internal strand Sensor with an internal fault that shows up intermittently Sensor ground or supply with an unstable contact Moisture in the connector Control unit input circuit problem (rare)
How do you fix code P2384?
First check the sensor connector and wiring, gently moving them with the engine running to see if the fault appears. It isn't an emergency, but an intermittent fault can get worse and become permanent, so don't leave it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2383 — EGR sensor D circuit: implausible or out-of-range...
- Next code: P2385 — EGR sensor E circuit: fault detected
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit