P2385 — EGR sensor E circuit: fault detected
| Meaning | The control unit has detected a general problem in the circuit of an EGR system sensor labelled "E". The code doesn't say whether the signal is high, low or unstable: it only reports that something in the circuit is wrong. Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so your car's service manual is needed. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Abnormal exhaust smoke
On some cars limp mode with reduced power
Common causes
Damaged, broken or shorted wiring
Faulty EGR sensor
Dirty or faulty EGR valve, if the sensor is built in
Sensor power or ground problem
Faulty control unit (rare)
What to do
How to read code P2385
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2385 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (85) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2385 mean?
EGR sensor E circuit: fault detected. The control unit has detected a general problem in the circuit of an EGR system sensor labelled "E". The code doesn't say whether the signal is high, low or unstable: it only reports that something in the circuit is wrong. Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so your car's service manual is needed.
Can I keep driving with code P2385 active?
With caution: limp mode possible, have it checked soon
Common causes — P2385
Corroded or loose sensor connector Damaged, broken or shorted wiring Faulty EGR sensor Dirty or faulty EGR valve, if the sensor is built in Sensor power or ground problem Faulty control unit (rare)
How do you fix code P2385?
Have a scan tool read the sensor data and check the wiring and connector. You can drive with care, but have the car checked fairly soon so the EGR system doesn't deteriorate.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2384 — EGR sensor D circuit: intermittent signal
- Next code: P2386 — EGR sensor E circuit: signal too high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit