P2386 — EGR sensor E circuit: signal too high
| Meaning | The control unit measured a higher-than-normal voltage on the circuit of the EGR sensor labelled "E". Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so check the service manual. In general this means a broken wire, the signal being pulled up to the supply voltage, or a sensor that no longer responds. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Loss of power or sluggish response
Exhaust smoke on diesels
On some cars the engine goes into limp mode
Common causes
Signal shorted to the supply voltage
Missing or corroded sensor ground
Faulty EGR sensor
Faulty EGR valve, if the sensor is built in
Faulty control unit (rare)
What to do
How to read code P2386
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2386 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (86) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2386 mean?
EGR sensor E circuit: signal too high. The control unit measured a higher-than-normal voltage on the circuit of the EGR sensor labelled "E". Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so check the service manual. In general this means a broken wire, the signal being pulled up to the supply voltage, or a sensor that no longer responds.
Can I keep driving with code P2386 active?
With caution: limp mode possible, have it checked soon
Common causes — P2386
Broken signal wire or unplugged connector Signal shorted to the supply voltage Missing or corroded sensor ground Faulty EGR sensor Faulty EGR valve, if the sensor is built in Faulty control unit (rare)
How do you fix code P2386?
First check the sensor connector, wiring and ground, then have the reading verified with a scan tool. This isn't a condition to ignore for long: better to have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2385 — EGR sensor E circuit: fault detected
- Next code: P2387 — EGR sensor E circuit: signal too low
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit