P2387 — EGR sensor E circuit: signal too low
| Meaning | The control unit measured a lower-than-normal voltage on the circuit of the EGR sensor labelled "E". Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so the service manual is needed. Usually the signal is shorted to ground, the sensor supply is missing, or the sensor is faulty. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
More visible exhaust smoke
On some cars limp mode
Common causes
Corroded connector or loose terminals
Missing sensor supply voltage
Faulty EGR sensor
Dirty or stuck EGR valve, if the sensor is built in
Faulty control unit (rare)
What to do
How to read code P2387
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2387 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (87) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2387 mean?
EGR sensor E circuit: signal too low. The control unit measured a lower-than-normal voltage on the circuit of the EGR sensor labelled "E". Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so the service manual is needed. Usually the signal is shorted to ground, the sensor supply is missing, or the sensor is faulty.
Can I keep driving with code P2387 active?
With caution: limp mode possible, have it checked soon
Common causes — P2387
Signal wire shorted to ground or with damaged insulation Corroded connector or loose terminals Missing sensor supply voltage Faulty EGR sensor Dirty or stuck EGR valve, if the sensor is built in Faulty control unit (rare)
How do you fix code P2387?
Inspect the sensor wiring and connector, and have a scan tool check that the supply voltage is arriving correctly. You can use the car with care, but don't leave the problem unchecked for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2386 — EGR sensor E circuit: signal too high
- Next code: P2388 — EGR sensor E circuit: implausible or out-of-range...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit