P2388 — EGR sensor E circuit: implausible or out-of-range signal
| Meaning | The control unit receives a signal from the EGR sensor labelled "E" that is present but doesn't match what is expected. Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so check the service manual. The fault may be in the sensor, or in the EGR system not behaving as commanded. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle or stalling at low rpm
Hesitation when accelerating
More exhaust smoke on diesels
Higher emissions at inspection
Common causes
Dirty or out-of-calibration EGR sensor
Blocked EGR passages or cooler
Leaks in the system's pipes
Wiring or connector with abnormal resistance
Faulty sensor
What to do
How to read code P2388
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2388 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (88) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2388 mean?
EGR sensor E circuit: implausible or out-of-range signal. The control unit receives a signal from the EGR sensor labelled "E" that is present but doesn't match what is expected. Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information, so check the service manual. The fault may be in the sensor, or in the EGR system not behaving as commanded.
Can I keep driving with code P2388 active?
With caution: limp mode possible, have it checked soon
Common causes — P2388
Dirty or partly stuck EGR valve Dirty or out-of-calibration EGR sensor Blocked EGR passages or cooler Leaks in the system's pipes Wiring or connector with abnormal resistance Faulty sensor
How do you fix code P2388?
Have a scan tool check whether the sensor reading follows the valve commands, and check the valve and passages for deposits. The car can be used with care, but it's best to act soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2387 — EGR sensor E circuit: signal too low
- Next code: P2389 — EGR sensor E circuit: intermittent signal
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit