P2389 — EGR sensor E circuit: intermittent signal
| Meaning | The control unit sees the signal from EGR sensor "E" appearing and disappearing or jumping around unrealistically. Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information. Usually a contact is dropping out now and then, with vibration or heat. |
| Family | Powertrain (P) |
Typical symptoms
Hunting idle
Occasional jerks or power dips
Fault that only appears when hot or on rough roads
Intermittent exhaust smoke
Common causes
Partly broken or chafed internal wire strand
Sensor with an intermittent internal fault
Ground or supply with an unstable contact
Moisture in the connector
Control unit input circuit problem (rare)
What to do
How to read code P2389
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2389 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (89) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2389 mean?
EGR sensor E circuit: intermittent signal. The control unit sees the signal from EGR sensor "E" appearing and disappearing or jumping around unrealistically. Which sensor "E" is depends on the manufacturer, and for some brands I have no reliable information. Usually a contact is dropping out now and then, with vibration or heat.
Can I keep driving with code P2389 active?
With caution: limp mode possible, have it checked soon
Common causes — P2389
Connector with corroded or loose contacts Partly broken or chafed internal wire strand Sensor with an intermittent internal fault Ground or supply with an unstable contact Moisture in the connector Control unit input circuit problem (rare)
How do you fix code P2389?
First check the connector and wiring, gently moving them with the engine running to see if the fault appears. It isn't an emergency, but an intermittent fault can become permanent, so don't wait too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2388 — EGR sensor E circuit: implausible or out-of-range...
- Next code: P238A — Water-in-fuel sensor B circuit: fault detected
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit