P238A — Water-in-fuel sensor B circuit: fault detected
| Meaning | The control unit has detected a general electrical problem in the circuit of the second sensor that monitors water in the diesel fuel (labelled "B"). The code doesn't say whether the signal is high, low or unstable. The sensor is usually in or near the fuel filter, but the exact location depends on the make. |
| Family | Powertrain (P) |
Typical symptoms
Water-in-fuel warning light or message that may come on wrongly
Longer-than-normal starting
Irregular engine running
No obvious symptoms in some cases
Common causes
Damaged or broken wiring
Faulty sensor
Moisture or corrosion on the contacts under the filter
Faulty sensor supply or ground
Faulty control unit (rare)
What to do
How to read code P238A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P238A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (8A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P238A mean?
Water-in-fuel sensor B circuit: fault detected. The control unit has detected a general electrical problem in the circuit of the second sensor that monitors water in the diesel fuel (labelled "B"). The code doesn't say whether the signal is high, low or unstable. The sensor is usually in or near the fuel filter, but the exact location depends on the make.
Can I keep driving with code P238A active?
With caution: limp mode possible, have it checked soon
Common causes — P238A
Corroded or loose sensor connector Damaged or broken wiring Faulty sensor Moisture or corrosion on the contacts under the filter Faulty sensor supply or ground Faulty control unit (rare)
How do you fix code P238A?
Check the sensor connector and wiring and, while you're at it, see whether there is water in the filter that needs draining, because a sensor can be reporting a real problem. Don't ignore the code: water in diesel can seriously damage the injection system.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2389 — EGR sensor E circuit: intermittent signal
- Next code: P238B — Water-in-fuel sensor B circuit: implausible signal
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit