P238B — Water-in-fuel sensor B circuit: implausible signal
| Meaning | The control unit receives from the second water-in-fuel sensor ("B") a signal that doesn't match what is expected. The electrical circuit isn't necessarily broken, but the value read makes no sense for the operating conditions. It may be the sensor itself, or real water or contamination in the fuel. |
| Family | Powertrain (P) |
Typical symptoms
Water-in-fuel light on or flickering
Hard starting
Rough idle
Loss of power in some cases
Common causes
Dirty, corroded or out-of-calibration sensor
Faulty sensor
Connector or wiring with abnormal resistance
Poor-quality or contaminated fuel
Faulty control unit (rare)
What to do
How to read code P238B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P238B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (8B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P238B mean?
Water-in-fuel sensor B circuit: implausible signal. The control unit receives from the second water-in-fuel sensor ("B") a signal that doesn't match what is expected. The electrical circuit isn't necessarily broken, but the value read makes no sense for the operating conditions. It may be the sensor itself, or real water or contamination in the fuel.
Can I keep driving with code P238B active?
With caution: limp mode possible, have it checked soon
Common causes — P238B
Water or dirt in the fuel filter Dirty, corroded or out-of-calibration sensor Faulty sensor Connector or wiring with abnormal resistance Poor-quality or contaminated fuel Faulty control unit (rare)
How do you fix code P238B?
First check whether there is water in the fuel filter and drain it as the manufacturer instructs, then have the sensor checked with a scan tool. Don't neglect the code: water in diesel can damage the pump and injectors.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P238A — Water-in-fuel sensor B circuit: fault detected
- Next code: P238C — Water-in-fuel sensor B circuit: signal too low
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit