P238C — Water-in-fuel sensor B circuit: signal too low
| Meaning | The control unit measured a lower-than-normal voltage on the circuit of the second water-in-fuel sensor ("B"). Usually this means the signal is shorted to ground, the supply is missing, or the sensor is faulty. On some cars a low value may also be read as the presence of water: it depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Water-in-fuel light on for no apparent reason
Longer starting
Irregular engine running
Sometimes no obvious symptoms
Common causes
Corroded, wet or loose connector
Missing sensor supply
Faulty sensor
Water actually present in the filter
Faulty control unit (rare)
What to do
How to read code P238C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P238C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (8C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P238C mean?
Water-in-fuel sensor B circuit: signal too low. The control unit measured a lower-than-normal voltage on the circuit of the second water-in-fuel sensor ("B"). Usually this means the signal is shorted to ground, the supply is missing, or the sensor is faulty. On some cars a low value may also be read as the presence of water: it depends on the manufacturer.
Can I keep driving with code P238C active?
With caution: limp mode possible, have it checked soon
Common causes — P238C
Signal wire shorted to ground Corroded, wet or loose connector Missing sensor supply Faulty sensor Water actually present in the filter Faulty control unit (rare)
How do you fix code P238C?
Check the sensor wiring and connector and check for water in the fuel filter. Have the value read with a scan tool and don't put it off: if the water is real, it can damage the injection system.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P238B — Water-in-fuel sensor B circuit: implausible signal
- Next code: P238D — Water-in-fuel sensor B circuit: signal too high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit