P238D — Water-in-fuel sensor B circuit: signal too high
| Meaning | The control unit measured a higher-than-normal voltage on the circuit of the second water-in-fuel sensor ("B"). Usually this means a broken wire, an unplugged connector, the signal pulled to the supply voltage, or a faulty sensor. The sensor may therefore no longer be able to warn you if water gets into the fuel. |
| Family | Powertrain (P) |
Typical symptoms
Water-in-fuel light flickering or on
Longer-than-normal starting
Irregular running in some cases
Sometimes no obvious symptoms
Common causes
Corroded contacts in the connector
Short to the supply voltage
Missing sensor ground
Faulty sensor
Faulty control unit (rare)
What to do
How to read code P238D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P238D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (8D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P238D mean?
Water-in-fuel sensor B circuit: signal too high. The control unit measured a higher-than-normal voltage on the circuit of the second water-in-fuel sensor ("B"). Usually this means a broken wire, an unplugged connector, the signal pulled to the supply voltage, or a faulty sensor. The sensor may therefore no longer be able to warn you if water gets into the fuel.
Can I keep driving with code P238D active?
With caution: limp mode possible, have it checked soon
Common causes — P238D
Broken signal wire or unplugged connector Corroded contacts in the connector Short to the supply voltage Missing sensor ground Faulty sensor Faulty control unit (rare)
How do you fix code P238D?
Check that the connector is firmly seated and the wiring is intact, then look for water in the filter. This is not a fault to ignore: while the sensor isn't working, water in the fuel may go unreported.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P238C — Water-in-fuel sensor B circuit: signal too low
- Next code: P238E — Water-in-fuel sensor B circuit: intermittent signa...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit