P238E — Water-in-fuel sensor B circuit: intermittent signal
| Meaning | The control unit sees the signal from the second water-in-fuel sensor ("B") appearing and disappearing or jumping around unrealistically. Usually it's a contact dropping out due to vibration, moisture or corrosion, but it may also be the sensor starting to fail. |
| Family | Powertrain (P) |
Typical symptoms
Water-in-fuel light appearing now and then
Starting sometimes longer
Occasional irregular running
Fault that comes and goes on rough roads or in bad weather
Common causes
Partly broken or chafed internal wire strand
Sensor with an intermittent internal fault
Moisture or corrosion under the filter
Ground or supply with an unstable contact
Water present at times in the filter
What to do
How to read code P238E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P238E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (8E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P238E mean?
Water-in-fuel sensor B circuit: intermittent signal. The control unit sees the signal from the second water-in-fuel sensor ("B") appearing and disappearing or jumping around unrealistically. Usually it's a contact dropping out due to vibration, moisture or corrosion, but it may also be the sensor starting to fail.
Can I keep driving with code P238E active?
With caution: limp mode possible, have it checked soon
Common causes — P238E
Corroded, wet or loose connector Partly broken or chafed internal wire strand Sensor with an intermittent internal fault Moisture or corrosion under the filter Ground or supply with an unstable contact Water present at times in the filter
How do you fix code P238E?
Check the connector and wiring, gently moving them to see if the fault appears, and check whether there is water in the filter. Don't let it go for long: an intermittent fault can get worse and hide a real presence of water.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P238D — Water-in-fuel sensor B circuit: signal too high
- Next code: P238F — Water in fuel detected by sensor B
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit