P238F — Water in fuel detected by sensor B
| Meaning | Through the second water-in-fuel sensor ("B"), the control unit has detected more water in the fuel than is allowed. This is not an electrical fault but a real condition reported by the sensor. Water in diesel is dangerous for the pump and injectors, which are lubricated by the fuel itself. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Hard starting or engine reluctant to start
Jerking, loss of power or engine stalling
White or irregular exhaust smoke
Abnormal noise from the injection system
Common causes
Condensation built up in the tank
Fuel filter saturated with water and not drained for a long time
Tank seals or cap letting moisture in
Sensor reporting wrongly (less likely)
What to do
How to read code P238F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P238F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (8F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P238F mean?
Water in fuel detected by sensor B. Through the second water-in-fuel sensor ("B"), the control unit has detected more water in the fuel than is allowed. This is not an electrical fault but a real condition reported by the sensor. Water in diesel is dangerous for the pump and injectors, which are lubricated by the fuel itself.
Can I keep driving with code P238F active?
With caution: limp mode possible, have it checked soon
Common causes — P238F
Refuelling with diesel containing water Condensation built up in the tank Fuel filter saturated with water and not drained for a long time Tank seals or cap letting moisture in Sensor reporting wrongly (less likely)
How do you fix code P238F?
Stop as soon as you can and don't push the engine: drain the water from the filter as the manufacturer instructs and have the fuel checked. Continuing to drive with water in the diesel can seriously damage the pump and injectors, so the urgency is high.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P238E — Water-in-fuel sensor B circuit: intermittent signa...
- Next code: P2390 — Diesel intake air flow B control: open circuit
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit