P2390 — Diesel intake air flow B control: open circuit
| Meaning | The control unit has detected an open, meaning broken, circuit in the control of the second device that regulates intake air flow on diesel engines (labelled "B"). Usually it's an intake valve or throttle flap, but which one exactly depends on the manufacturer, and for some brands I have no reliable information. The control unit cannot command it. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Rough idle
Black or abnormal exhaust smoke
Engine stalling when you lift off on some cars
Limp mode on some cars
Common causes
Broken control wire
Faulty actuator or valve motor
Missing actuator supply or ground
Faulty control unit (rare)
What to do
How to read code P2390
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2390 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (90) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2390 mean?
Diesel intake air flow B control: open circuit. The control unit has detected an open, meaning broken, circuit in the control of the second device that regulates intake air flow on diesel engines (labelled "B"). Usually it's an intake valve or throttle flap, but which one exactly depends on the manufacturer, and for some brands I have no reliable information. The control unit cannot command it.
Can I keep driving with code P2390 active?
With caution: limp mode possible, have it checked soon
Common causes — P2390
Actuator connector unplugged, corroded or loose Broken control wire Faulty actuator or valve motor Missing actuator supply or ground Faulty control unit (rare)
How do you fix code P2390?
First check the actuator connector and wiring, and have a scan tool verify whether it responds to commands. You can drive with care, but it's best not to delay because air management affects how the engine runs.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P238F — Water in fuel detected by sensor B
- Next code: P2391 — Diesel intake air flow B control: performance prob...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit