Skip to content
Fault code dictionary (DTC)

P23B0 — NOx sensor bank 1 sensor 3: intermittent circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module loses the NOx sensor signal from time to time, and it drops out or returns to normal without a fixed pattern. It usually points to an unstable contact: a connector, a wire breaking with vibration, or a sensor that is about to fail. Where sensor 3 sits depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light coming on and going off
AdBlue system warnings that appear on and off, if fitted
Occasional power limitation
Higher emissions while the fault is present
Problem that gets worse with vibration or moisture

Common causes

Connector with weak or corroded contact
Wire partly broken by vibration
NOx sensor starting to fail
Wiring chafed or close to hot parts
Ground or supply with an unstable contact

What to do

Carefully wiggle the connector and wiring while the data is being read to see if the signal drops. Have ground and supply checked. Intermittent faults tend to get worse, so it is better to deal with it early.

How to read code P23B0

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P23B0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B0) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P23B0 mean?

NOx sensor bank 1 sensor 3: intermittent circuit. The control module loses the NOx sensor signal from time to time, and it drops out or returns to normal without a fixed pattern. It usually points to an unstable contact: a connector, a wire breaking with vibration, or a sensor that is about to fail. Where sensor 3 sits depends on the manufacturer.

Can I keep driving with code P23B0 active?

With caution: limp mode possible, have it checked soon

Common causes — P23B0

Connector with weak or corroded contact Wire partly broken by vibration NOx sensor starting to fail Wiring chafed or close to hot parts Ground or supply with an unstable contact

How do you fix code P23B0?

Carefully wiggle the connector and wiring while the data is being read to see if the signal drops. Have ground and supply checked. Intermittent faults tend to get worse, so it is better to deal with it early.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes