P23B1 — NOx sensor bank 1 sensor 3: heater control circuit open
| Meaning | The NOx sensor has a small heater that brings it up to temperature so it can measure properly. The control module detected that the heater control circuit is open or broken. Without heating, the sensor does not work well. Where sensor 3 sits varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Connector with broken or corroded contact
Broken heater wiring
Fuse or heater supply problem
Sensor control unit failure
What to do
How to read code P23B1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23B1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23B1 mean?
NOx sensor bank 1 sensor 3: heater control circuit open. The NOx sensor has a small heater that brings it up to temperature so it can measure properly. The control module detected that the heater control circuit is open or broken. Without heating, the sensor does not work well. Where sensor 3 sits varies by manufacturer.
Can I keep driving with code P23B1 active?
With caution: limp mode possible, have it checked soon
Common causes — P23B1
Burnt-out heater inside the sensor Connector with broken or corroded contact Broken heater wiring Fuse or heater supply problem Sensor control unit failure
How do you fix code P23B1?
First check the connector, wiring and fuses for the sensor. Then have the heater resistance measured. Don't wait too long, because the system can limit power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23B0 — NOx sensor bank 1 sensor 3: intermittent circuit
- Next code: P23B2 — NOx sensor bank 1 sensor 3: heater control circuit...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit