P23B2 — NOx sensor bank 1 sensor 3: heater control circuit low
| Meaning | The control module sees that the NOx sensor heater control circuit has a signal that is too low, usually from a short to ground or a fault in the heater. Without heating, the sensor does not measure correctly. The position of sensor 3 changes by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Shorted heater inside the sensor
Damaged or wet connector
Wiring damaged by heat
Sensor control unit failure
What to do
How to read code P23B2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23B2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23B2 mean?
NOx sensor bank 1 sensor 3: heater control circuit low. The control module sees that the NOx sensor heater control circuit has a signal that is too low, usually from a short to ground or a fault in the heater. Without heating, the sensor does not measure correctly. The position of sensor 3 changes by manufacturer.
Can I keep driving with code P23B2 active?
With caution: limp mode possible, have it checked soon
Common causes — P23B2
Heater control wire shorted to ground Shorted heater inside the sensor Damaged or wet connector Wiring damaged by heat Sensor control unit failure
How do you fix code P23B2?
First check the sensor wiring and connector, looking for wires shorted to ground or heat damage. Then have the heater circuit measured. Don't ignore the code for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23B1 — NOx sensor bank 1 sensor 3: heater control circuit...
- Next code: P23B3 — NOx sensor bank 1 sensor 3: heater control circuit...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit