P23B3 — NOx sensor bank 1 sensor 3: heater control circuit high
| Meaning | The control module sees that the NOx sensor heater control circuit has a signal that is too high, for example from a short to the supply or a fault in the driver. The heater does not work as expected and the sensor may read wrongly. Where sensor 3 sits varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Damaged or wet connector
Pinched or burnt wiring
Faulty NOx sensor
Sensor or engine control module failure, which is rare
What to do
How to read code P23B3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23B3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23B3 mean?
NOx sensor bank 1 sensor 3: heater control circuit high. The control module sees that the NOx sensor heater control circuit has a signal that is too high, for example from a short to the supply or a fault in the driver. The heater does not work as expected and the sensor may read wrongly. Where sensor 3 sits varies by manufacturer.
Can I keep driving with code P23B3 active?
With caution: limp mode possible, have it checked soon
Common causes — P23B3
Heater control wire touching the supply Damaged or wet connector Pinched or burnt wiring Faulty NOx sensor Sensor or engine control module failure, which is rare
How do you fix code P23B3?
First check wiring and connector, looking for wires touching each other. Then have the heater control verified. Don't leave it for long, because the system can reduce power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23B2 — NOx sensor bank 1 sensor 3: heater control circuit...
- Next code: P23B4 — NOx sensor bank 1 sensor 3: heater sense circuit f...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit