P23B4 — NOx sensor bank 1 sensor 3: heater sense circuit fault
| Meaning | The control module detected a fault in the circuit that monitors how the NOx sensor heater is working. This circuit lets it know whether the heater is really operating. The code is general, so the exact cause is found with further measurements. Where sensor 3 sits depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Failed emissions inspection
Common causes
Damaged heater sense wiring
Faulty NOx sensor
Sensor supply or ground problem
Sensor control unit failure
What to do
How to read code P23B4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23B4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23B4 mean?
NOx sensor bank 1 sensor 3: heater sense circuit fault. The control module detected a fault in the circuit that monitors how the NOx sensor heater is working. This circuit lets it know whether the heater is really operating. The code is general, so the exact cause is found with further measurements. Where sensor 3 sits depends on the manufacturer.
Can I keep driving with code P23B4 active?
With caution: limp mode possible, have it checked soon
Common causes — P23B4
Corroded or wet sensor connector Damaged heater sense wiring Faulty NOx sensor Sensor supply or ground problem Sensor control unit failure
How do you fix code P23B4?
First check the sensor connector and wiring. Then have the sensor data read and the circuits measured. Don't wait too long, because the system can limit power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23B3 — NOx sensor bank 1 sensor 3: heater control circuit...
- Next code: P23B5 — NOx sensor bank 1 sensor 3: heater sense range/per...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit