P23B6 — NOx sensor bank 1 sensor 3: supply voltage circuit fault
| Meaning | The control module detected a problem with the electrical supply to the NOx sensor. The voltage the sensor receives is outside the expected limits, so it may work badly or not at all. Where sensor 3 sits depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Warning from the AdBlue or exhaust system, if fitted
Possible power limitation
Higher emissions
Sometimes other battery- or supply-related codes
Common causes
Corroded connector or weak contact
Damaged supply or ground wiring
Battery or charging system with unstable voltage
Faulty NOx sensor
Failure of the control module that powers the sensor
What to do
How to read code P23B6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23B6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (B6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23B6 mean?
NOx sensor bank 1 sensor 3: supply voltage circuit fault. The control module detected a problem with the electrical supply to the NOx sensor. The voltage the sensor receives is outside the expected limits, so it may work badly or not at all. Where sensor 3 sits depends on the manufacturer.
Can I keep driving with code P23B6 active?
With caution: limp mode possible, have it checked soon
Common causes — P23B6
Fuse or relay problem on the sensor supply Corroded connector or weak contact Damaged supply or ground wiring Battery or charging system with unstable voltage Faulty NOx sensor Failure of the control module that powers the sensor
How do you fix code P23B6?
First check battery condition, fuses and grounds. Then have the voltage reaching the sensor measured. Don't wait too long, because the system can limit power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23B5 — NOx sensor bank 1 sensor 3: heater sense range/per...
- Next code: P23B7 — NOx sensor bank 1 sensor 3: heater control range/p...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit