Skip to content
Fault code dictionary (DTC)

P23C0 — NOx sensor 3 bank 1: slow response from high to low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningWhen the amount of NOx (nitrogen oxides) in the exhaust drops, sensor number 3 follows the change too slowly. The control unit considers the measurement unreliable. Which sensor is number 3 varies by manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Emissions system warning message
Possible power reduction
Irregular exhaust additive dosing
Often no driving symptom

Common causes

Aged NOx sensor
Sensing element contaminated by deposits
Exhaust gas leaks
Connector or wiring in poor condition
Fault in the sensor control module

What to do

Have the sensor values read live and check the exhaust and connectors. Do not leave the problem for long, as it can get worse and lead to restrictions.

How to read code P23C0

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P23C0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (C0) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P23C0 mean?

NOx sensor 3 bank 1: slow response from high to low. When the amount of NOx (nitrogen oxides) in the exhaust drops, sensor number 3 follows the change too slowly. The control unit considers the measurement unreliable. Which sensor is number 3 varies by manufacturer.

Can I keep driving with code P23C0 active?

With caution: limp mode possible, have it checked soon

Common causes — P23C0

Aged NOx sensor Sensing element contaminated by deposits Exhaust gas leaks Connector or wiring in poor condition Fault in the sensor control module

How do you fix code P23C0?

Have the sensor values read live and check the exhaust and connectors. Do not leave the problem for long, as it can get worse and lead to restrictions.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes