P23C1 — NOx sensor 3 bank 1: sensing element fault
| Meaning | The control unit detected a problem in the element that measures NOx (nitrogen oxides) inside sensor number 3. The sensor no longer gives a correct measurement. Test details vary by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system warning message
Possible power limitation
Unusual exhaust additive consumption
No obvious symptom in many cases
Common causes
Contamination by deposits or liquids
Sensor damaged by impact or excessive heat
Damaged wiring or connector
Fault in the sensor control module
What to do
How to read code P23C1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P23C1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (C1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P23C1 mean?
NOx sensor 3 bank 1: sensing element fault. The control unit detected a problem in the element that measures NOx (nitrogen oxides) inside sensor number 3. The sensor no longer gives a correct measurement. Test details vary by manufacturer.
Can I keep driving with code P23C1 active?
With caution: limp mode possible, have it checked soon
Common causes — P23C1
Worn-out internal NOx sensor element Contamination by deposits or liquids Sensor damaged by impact or excessive heat Damaged wiring or connector Fault in the sensor control module
How do you fix code P23C1?
The sensor usually needs to be checked with diagnostic tools and replaced if confirmed faulty. Do not wait too long, as the emissions system may restrict driving.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P23C0 — NOx sensor 3 bank 1: slow response from high to lo...
- Next code: P23C2 — NOx sensor 3 bank 1: delayed response from high to...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit