Skip to content
Fault code dictionary (DTC)

P2449 — Secondary air system bank 2: air flow too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer measures more air in the bank 2 secondary air system than should be passing through. It could come from a valve letting air through when it shouldn't, a sensor reading wrongly, or a leak distorting the measurement. I have no basis to point to a single cause, so the circuit needs checking. Bank 2 is the row of cylinders opposite cylinder 1.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Altered emissions after a cold start
Possible other codes on the valve, pump or oxygen sensors
Air noise from the circuit
Usually no difference in driving

Common causes

Switching valve that doesn't close properly
Flow or pressure sensor reading too high
Pump that keeps running at the wrong time
Disconnected or damaged hoses distorting the measurement
Wiring or connector with poor contacts

What to do

First check that the bank 2 valve closes properly and that the hoses are intact, and see whether other secondary air codes are stored. It isn't a safety emergency, but shouldn't be ignored for long.

How to read code P2449

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2449 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (49) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2449 mean?

Secondary air system bank 2: air flow too high. The engine computer measures more air in the bank 2 secondary air system than should be passing through. It could come from a valve letting air through when it shouldn't, a sensor reading wrongly, or a leak distorting the measurement. I have no basis to point to a single cause, so the circuit needs checking. Bank 2 is the row of cylinders opposite cylinder 1.

Can I keep driving with code P2449 active?

With caution: limp mode possible, have it checked soon

Common causes — P2449

Switching valve that doesn't close properly Flow or pressure sensor reading too high Pump that keeps running at the wrong time Disconnected or damaged hoses distorting the measurement Wiring or connector with poor contacts

How do you fix code P2449?

First check that the bank 2 valve closes properly and that the hoses are intact, and see whether other secondary air codes are stored. It isn't a safety emergency, but shouldn't be ignored for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes