P244A — Diesel Particulate Filter Pressure Too Low
| Meaning | The engine control unit has detected that the exhaust pressure before the diesel particulate filter is lower than expected. This usually means the sensor is not seeing the normal restriction, or there is an issue with the exhaust flow and pressure sensing system. |
| Family | Powertrain (P) |
Typical symptoms
Possible reduced engine performance or limp mode
Common causes
Leak in the exhaust system before the particulate filter
Damage or modification to the diesel particulate filter
What to do
How to read code P244A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P244A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (4A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P244A mean?
Diesel Particulate Filter Pressure Too Low. The engine control unit has detected that the exhaust pressure before the diesel particulate filter is lower than expected. This usually means the sensor is not seeing the normal restriction, or there is an issue with the exhaust flow and pressure sensing system.
Can I keep driving with code P244A active?
With caution: limp mode possible, have it checked soon
Common causes — P244A
Faulty exhaust pressure sensor or blocked pressure pipes Leak in the exhaust system before the particulate filter Damage or modification to the diesel particulate filter
How do you fix code P244A?
Have a mechanic check the pressure sensor pipes for cracks, blockages, or disconnections as soon as possible. Avoid heavy driving until the system is inspected to prevent potential engine management issues.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2447 — Secondary Air Injection System Pump Stuck Off Bank...
- Next code: P244D — EXHAUST TEMPERATURE TOO HIGH FOR PARTICULATE FILTE...
Related codes
- P2400 — Evaporative Emission System Leak Detection Pump Control Circ...
- P2401 — Evaporative Emission System Leak Detection Pump Control Circ...
- P2402 — Evaporative Emission System Leak Detection Pump Control Circ...
- P2403 — Evaporative Emission System Leak Detection Pump Sense Circui...
- P2404 — Evaporative Emission System Leak Detection Pump Sense Circui...
- P2405 — Evaporative Emission System Leak Detection Pump Sense Circui...
- P2406 — Evaporative Emission System Leak Detection Pump Sense Circui...
- P2407 — Evaporative Emission System Leak Detection Pump Sense Circui...
- P2408 — Fuel Cap Sensor/Switch Circuit
- P2409 — Fuel Cap Sensor/Switch Circuit Range/Performance
- P240A — The engine speed of the engine system is implausible.
- P240B — The engine speed sent from the engine control unit via the C...