P2478 — Exhaust gas temp out of range, bank 1 sensor 1
| Meaning | The engine control unit found that the exhaust gas temperature sensor labeled bank 1 sensor 1 reads outside the range expected for current driving conditions. Bank 1 is the side of the engine that holds cylinder number 1. Manufacturers decide how exhaust temperature sensors are numbered, so check the exact position in your car's wiring or service information. |
| Family | Powertrain (P) |
Typical symptoms
Possible particulate filter or exhaust warning light
Loss of power or reduced-power mode
More frequent or unusual filter regenerations
More visible exhaust smoke than usual
Common causes
Damaged or corroded sensor wiring or connector
Exhaust leak near the sensor
Clogged or degraded catalytic converter or filter
Combustion problem causing abnormal temperatures
Control unit fault, which is rare
What to do
How to read code P2478
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2478 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (78) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2478 mean?
Exhaust gas temp out of range, bank 1 sensor 1. The engine control unit found that the exhaust gas temperature sensor labeled bank 1 sensor 1 reads outside the range expected for current driving conditions. Bank 1 is the side of the engine that holds cylinder number 1. Manufacturers decide how exhaust temperature sensors are numbered, so check the exact position in your car's wiring or service information.
Can I keep driving with code P2478 active?
With caution: limp mode possible, have it checked soon
Common causes — P2478
Faulty or contaminated temperature sensor Damaged or corroded sensor wiring or connector Exhaust leak near the sensor Clogged or degraded catalytic converter or filter Combustion problem causing abnormal temperatures Control unit fault, which is rare
How do you fix code P2478?
Start by checking the sensor connector and wiring, and look for exhaust leaks along the pipe. Short trips are possible, but don't ignore it: abnormal temperatures can damage the catalytic converter and filter. Have live data read to tell whether the sensor is wrong or the temperature is really abnormal.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2477 — Exhaust temperature sensor erratic, bank 2 sensor...
- Next code: P2479 — Exhaust gas temp out of range, bank 1 sensor 2
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible