P2477 — Exhaust temperature sensor erratic, bank 2 sensor 4
| Meaning | The signal from sensor 4 on bank 2 comes and goes or jumps irregularly. This is typical of an electrical contact that breaks now and then, for example from vibration or heat. The control unit cannot use the reading continuously to manage the particulate filter. |
| Family | Powertrain (P) |
Typical symptoms
Irregular filter regeneration
Intermittent loss of power
Variable diesel consumption
Common causes
Sensor wire broken internally by vibration
Wiring rubbing against engine or exhaust parts
Faulty temperature sensor
Rarely, a faulty engine control unit
What to do
How to read code P2477
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2477 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (77) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2477 mean?
Exhaust temperature sensor erratic, bank 2 sensor 4. The signal from sensor 4 on bank 2 comes and goes or jumps irregularly. This is typical of an electrical contact that breaks now and then, for example from vibration or heat. The control unit cannot use the reading continuously to manage the particulate filter.
Can I keep driving with code P2477 active?
With caution: limp mode possible, have it checked soon
Common causes — P2477
Loose connector or corroded contacts Sensor wire broken internally by vibration Wiring rubbing against engine or exhaust parts Faulty temperature sensor Rarely, a faulty engine control unit
How do you fix code P2477?
Check that the connector is fully seated and, with a cold engine, gently move the wiring to see whether the fault appears. Intermittent faults are the hardest to find, so a test in a workshop with the engine running may be needed. It isn't an emergency, but don't leave it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2476 — Exhaust temperature sensor signal too high, bank 2...
- Next code: P2478 — Exhaust Gas Temperature Out of Range Bank 1 Sensor...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible