P2490 — EGR cooler bypass control bank 2: signal too low
| Meaning | The control unit detected that the electrical command signal to the EGR cooler bypass valve on bank 2 is lower than expected. This usually points to a short to ground in the wiring or the actuator. Bank 2 is the second cylinder bank of the engine. |
| Family | Powertrain (P) |
Typical symptoms
Bypass valve not moving
Loss of smoothness or power in some conditions
Increased emissions or smoke
No noticeable driving symptom in some cases
Common causes
Damaged connector or one with water inside
Bypass valve actuator with an internal short
Wiring damaged by heat or chafing
Faulty engine control unit (rare)
What to do
How to read code P2490
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2490 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (90) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2490 mean?
EGR cooler bypass control bank 2: signal too low. The control unit detected that the electrical command signal to the EGR cooler bypass valve on bank 2 is lower than expected. This usually points to a short to ground in the wiring or the actuator. Bank 2 is the second cylinder bank of the engine.
Can I keep driving with code P2490 active?
With caution: limp mode possible, have it checked soon
Common causes — P2490
Control wire shorted to ground Damaged connector or one with water inside Bypass valve actuator with an internal short Wiring damaged by heat or chafing Faulty engine control unit (rare)
How do you fix code P2490?
First check the bank 2 bypass valve wiring, looking for melted insulation or wires touching ground. Have it checked soon so that unregulated recirculation doesn't damage other parts.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P248F — EGR cooler bypass control bank 2: performance out...
- Next code: P2491 — EGR cooler bypass control bank 2: signal too high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible