P2491 — EGR cooler bypass control bank 2: signal too high
| Meaning | The control unit detected that the command signal to the EGR cooler bypass valve on bank 2 is higher than expected. This usually points to a short to supply voltage or a fault in the control circuit. Bank 2 is the second cylinder bank of the engine. |
| Family | Powertrain (P) |
Typical symptoms
Bypass valve not responding to commands
Loss of smoothness or power in some conditions
Increased emissions or smoke
No noticeable driving symptom in some cases
Common causes
Damaged or corroded connector
Faulty bypass valve actuator
Wiring damaged by heat
Faulty engine control unit (rare)
What to do
How to read code P2491
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2491 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (91) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2491 mean?
EGR cooler bypass control bank 2: signal too high. The control unit detected that the command signal to the EGR cooler bypass valve on bank 2 is higher than expected. This usually points to a short to supply voltage or a fault in the control circuit. Bank 2 is the second cylinder bank of the engine.
Can I keep driving with code P2491 active?
With caution: limp mode possible, have it checked soon
Common causes — P2491
Control wire shorted to supply voltage Damaged or corroded connector Faulty bypass valve actuator Wiring damaged by heat Faulty engine control unit (rare)
How do you fix code P2491?
First check the wiring and connector of the bank 2 bypass valve, looking for exposed wires or damaged contacts. Don't leave the problem for long, because an uncontrolled valve can worsen the condition of the EGR system.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2490 — EGR cooler bypass control bank 2: signal too low
- Next code: P2492 — EGR cooler bypass position sensor circuit bank 1:...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible