P2494 — EGR bypass position sensor bank 1: signal too low
| Meaning | The signal from the sensor reporting the EGR cooler bypass valve position on bank 1 is below the expected value. This usually points to a short to ground or a missing supply to the sensor. The control unit loses precise control of the valve. |
| Family | Powertrain (P) |
Typical symptoms
Engine running less smoothly in some conditions
Increased emissions or smoke
Possible power limitation
No noticeable driving symptom in some cases
Common causes
Interrupted supply to the sensor
Corroded or damaged connector
Faulty position sensor
Faulty engine control unit (rare)
What to do
How to read code P2494
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2494 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (94) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2494 mean?
EGR bypass position sensor bank 1: signal too low. The signal from the sensor reporting the EGR cooler bypass valve position on bank 1 is below the expected value. This usually points to a short to ground or a missing supply to the sensor. The control unit loses precise control of the valve.
Can I keep driving with code P2494 active?
With caution: limp mode possible, have it checked soon
Common causes — P2494
Signal wire shorted to ground Interrupted supply to the sensor Corroded or damaged connector Faulty position sensor Faulty engine control unit (rare)
How do you fix code P2494?
First check the wiring and connector of the bank 1 sensor, looking for wires touching ground or damaged contacts. Have it checked soon rather than waiting for the problem to worsen.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2493 — EGR cooler bypass position sensor bank 1: reading...
- Next code: P2495 — EGR bypass position sensor bank 1: signal too high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible